I have a LinkIt ONE that is no longer able to communicate over USB to my Mac. I have another LinkIt ONE that is able to communicate over USB to my Mac with no issue.
Is it possible to perform a factory reset on this device? If so, how?
Update the firmware and it may work again
Thanks Arturo but unfortunately the USB port is not detected even when I try to update the firmware.
Do you have changed the Serial port in the Arduino IDE, right?
I have tried various serial port configurations.
Is the onboard LED on, if you power the board? I habe this problem and can not access the board over USB too. the USB connection comes and goes after a few seconds. Im Using WIn7,